[Bonmin] Bonmin-AMPL

[Pierre Bonami]

Hi,
Probably you are not running mytoy correctly.
mytoy.nl being an nl file you have to run it like described here:
http://www.coin-or.org/Bonmin/use/index.html#sec:run_nl
for using Bonmin within ampl there is a simple example also on the  
same page.

Regards,
Pierre
On Apr 25, 2009, at 6:29 AM, Fabio Rossetto Libero wrote:

> Hi,
>
> i’m Fabio, i have a problem to run Bonmin with AMPL. I installed  
> AMPL in the same bonmin.exe directory but when I go to the “mytoy”  
> test I get this:
>
> …
>
> 4 variables:
>
>                 1 binary variables
>
>                 1 integer variables
>
>                 2 nonlinear variables
>
> 3 constraints; 7 linear nonzeros
>
>                 1 nonlinear constraints
>
>                 2 linear constraints
>
> 1 linear objective; 3 nonzeros.
>
> exit code 3221225781
>
> <BREAK>
>
> I must however say, when i was starting mytoy.nl  commands were not  
> recognized and what is obtained are the following lines of code:
>
> …
>
> test/mytoy.nl:line 50: 2: command not found
>
> test/mytoy.nl:line 51: 3: command not found
>
> test/mytoy.nl:line 52: G0: command not found
>
> test/mytoy.nl:line 53: 0: command not found
>
> test/mytoy.nl:line 54: 1: command not found
>
> test/mytoy.nl:line 55: 2: command not found
>
> Where i wrong? Thank you very much for your patience.
>
> Regards
>
> Fabio Rossetto
>
>
>
> _______________________________________________
> Bonmin mailing list
> Bonmin at list.coin-or.org
> http://list.coin-or.org/mailman/listinfo/bonmin

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://list.coin-or.org/pipermail/bonmin/attachments/20090427/9b8e147c/attachment.html